ART Clutch

Building, Rebuilding a Dragbike

Moderators: gregg dahl, Jayne

Posts: 9
Joined: Thu Jan 24, 2013 1:02 am

ART Clutch

Postby bigblock57 » Tue Jun 25, 2013 5:40 am

I have an ART slider clutch off a Harley dragbike and need some help to get some new plates for it and how to set it up.
DSC00088.JPG (152.95 KiB) Viewed 3320 times

The outside diameter is 6.375 inch.
Accross the plate from bottom of the cutout to bottom of cutout is 5.975 inch.
Inside diameter is 4.250 inch
Thickness of the steel is .750
I'm not sure of the thickness of the friction material as they are well worn.
The material looks to be sintered bronze.
DSC00087.JPG (149.33 KiB) Viewed 3320 times

This is the slider assembly any advice on how to set it up would be great.
Thanks in advance for any help.

User avatar
Posts: 73
Joined: Mon Jan 21, 2013 9:56 am

Re: ART Clutch

Postby Blastem » Tue Jun 25, 2013 8:57 pm

These folks can help or Steer ya..ask for Kent..
"LET OUR CHILDREN RACE" !!!!!!!!!!!!!!

Posts: 57
Joined: Tue Feb 21, 2006 3:21 pm
Location: Wis. Rapids, Wis.

Re: ART Clutch

Postby pg95 » Tue Jun 25, 2013 10:50 pm

Energy one was my choice when I made the change to a slider. Very good people to work with.

Posts: 9
Joined: Thu Jan 24, 2013 1:02 am

Re: ART Clutch

Postby bigblock57 » Wed Jun 26, 2013 3:47 am

Thanks for pointing me i the right direction.

Return to “Bike Building 101”

Who is online

Users browsing this forum: No registered users and 2 guests